byte _buffer[6]; // Array to store the raw sensor output char POWER_CTL = 0x2D; // Sensor power control register address char DATA_FORMAT = 0x31; // Sensor data format register address char DATAX0 = ...
Usually light dependent resistors (LDR) and photodiodes are used as light sensors to activate or deactivate circuits based on the presence or absence of light. But a common transparent LED can also be ...
€ 15,00 Adafruit Feather HUZZAH with ESP8266 € 19,00 Adafruit ADXL345 - Triple-Axis Accelerometer (+-2g/4g/8g/16g) € 10,00 2500mAh Li-Po rechargeable battery with JST-connector € 4,00 Half-size ...
V-LED This is the VCC pin of the LED. Connect this pin to the 5V pin of the Arduino with a 150Ω Current Limiting Resistor. LED-GND This is the Ground Pin of the LED. Connect this pin to the Ground pin ...
The pulse sensor comes with a flat ribbon cable with three male header connectors. The Pinout of the Pulse sensor is given below: S(Signal) is the Analog output pin of the Sensor Module that will give ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results